Issue Description

I am receiving the following error message in UltraBOM: “Lable or Digi-Key PN do not match Digi-Key Part Number.” How can I resolve this error?

 

Suggested Solution

This type of error may occur because your Digi-Key property for Manufacturer is set to label and the Manufacturer PN is set to Digi-Key PN while the Details page indicates there are two Digi-Key attributes mapped to the same Capture property.

 

To resolve this error, change the mapping in the Settings as shown in the screen capture below. If it is not available in the drop-down selection list, you may type in the value.